Configuring a configuration

You can configure a configuration.

1. Click Project Browser… button to select a project which this new configuration is created for. 2. Choose the project. 3. Click Search Project... to search all elfs belong to this project. 4. Select a qualified ELF.

To specify debugger tab:

1. Click Vendor and Device combo boxes to select vendor and device accroding to your project.
2. After Vendor and Device are selected, Read/only Memory Area and Read/wirte Memory Area will be automatically presented.These two areas show the avaiable addresses information accroding the chip. JTAG Speed is also automatically selected. You’d better not change the speed, because the speed is the max speed accroding the chip.

To specify Download tab:

1. If Setup section is checked, the program will be downloaded into the chip before debugging.
2. These radio buttons determine the way of erasion.
3. Add... Remove default are used to configurate program downloading algorithm.